Rudder
From Wikipedia, the free encyclopedia
A rudder is a device used to steer ships, boats, submarines, aircraft, hovercraft or other conveyances that move through air or water. Rudders operate by re-directing the flow of air or water past the hull or fuselage, thus imparting a turning or yawing motion to the craft. In basic form, a rudder is a flat plane or sheet of material attached with hinges to the craft's stern, tail or after end. Often rudders are shaped so as to minimize hydrodynamic or aerodynamic drag. On simple watercraft, a tiller—essentially, a stick or pole acting as a lever arm—may be attached to the top of the rudder to allow it to be steered by a helmsman. In larger vessels, cables, pushrods and hydraulics may be used to link rudders to steering wheels. In typical aircraft, pedals operate rudders via mechanical linkages.
Contents |
[edit] History of the rudder
[edit] Early history
Oars mounted on the side of ships for steering are documented from the 3rd millennium BCE in Ancient Egypt in artwork, wooden models, and even remnants of actual boats. An early example of an oar mounted on the stern is found in the Egyptian tomb of Menna (1422-1411 BC). Stern mounted oars were also quite common in Roman times as proved from numerous depictions.
[edit] China
The world's oldest known depiction of a stern-mounted rudder can be seen on a pottery model of a Chinese junk dating from the 1st century CE, predating their appearance in the West by a thousand years. The Chinese stern-mounted rudder is hung from the stern, held in place and controlled with a rope mechanism. Also, many junks incorporated "fenestrated rudders" (rudders with holes in them, allowing for better control), an innovation adopted in the West in 1901 to increase the manoeuvrability of torpedo boats. Detailed descriptions of Chinese junks during the Middle Ages are known from various travellers to China, such as Ibn Battuta and Marco Polo.
[edit] Europe
Oars mounted on the side of ships evolved into quarter rudders, which were used in Antiquity until the end of the Middle Ages in Europe. As the size of ships and the height of the freeboards increased, quarter-rudders became less satisfactory and were replaced in Europe by the more sturdy stern-mounted rudders with pintle and gudgeon attachment from the 12th century. The West's oldest known depiction of a stern-mounted rudder can be found on church carvings dating to around 1180.
The stern-mounted rudder in the West, whose technical specifications considerably differ from the Chinese one, was most probably invented independently:
- The only actual concept which can be claimed to have been transmitted from the Chinese is the idea of a stern-mounted rudder, and not its method of attachment nor the manner in which it was controlled. Since that idea of putting a rudder on the stern can be traced back to the models found in Egyptian tombs, the need to have the concept brought into the Middle East is questionable at best. There is no evidence to support the contention that the sternpost-mounted rudder came from China, and no need to call on exterior sources for its introduction into the Mediterranean.[1]
[edit] Arabs
The Arabs also used a sternpost-mounted rudder which differed technically from both its European and Chinese counterparts. On their ships "the rudder is controlled by two lines, each attached to a crosspiece mounted on the rudder head perpendicular to the plane of the rudder blade."[2] The earliest evidence comes from the Ahsan al-Taqasim fi Marifat al-Aqalim (The Best Divisions for the Classification of Regions) written by al-Muqaddasi in 985:
- The captain from the crow's nest carefully observes the sea. When a rock is espied, he shouts: "Starboard!" or 'Port!" Two youths, posted there, repeat the cry. The helmsman, with two ropes in his hand, when he hears the calls tugs one or the other to the right or left. If great care is not taken, the ship strikes the rocks and is wrecked.[3]
[edit] Technical details
Boat rudders may be either outboard or inboard. Outboard rudders are hung on the stern or transom. Inboard rudders are hung from a keel or skeg and are thus fully submerged beneath the hull, connected to the steering mechanism by a rudder post which comes up through the hull to deck level, often into a cockpit.
Some sailors use rudder post and mast placement to define the difference between a ketch and a yawl, similar two-masted vessels. Yawls are defined as having the mizzen mast abaft (ie. "aft of") the rudder post; ketches are defined as having the mizzen mast forward of the rudder post.
Small boat rudders that can be steered more or less perpendicular to the hull's longitudinal axis make effective brakes when pushed "hard over." However, terms such as "hard over," "hard to starboard," etc. signify a maximum-rate turn for larger vessels.
[edit] Aircraft rudders
On an aircraft, the rudder is called a "control surface" along with the rudder-like elevator (attached to horizontal tail structure) and ailerons (attached to the wings) that control pitch and roll respectively. The rudder is usually attached to the fin (or vertical stabilizer) which allows the pilot to control yaw in the horizontal axis, ie change the horizontal direction in which the nose is pointing. The rudder's direction is manipulated with the movement of foot pedals by the pilot.
In practice, both aileron and rudder control input are used together to turn an aircraft, the ailerons imparting roll, the rudder imparting yaw, and also compensating for a phenomenon called adverse yaw. Adverse yaw is readily seen if the ailerons alone are used for a turn. The downward moving aileron acts like a flap, generating more lift for one wing, and therefore more drag. Initially, this drag yaws the aircraft in the direction opposite to the desired course. A rudder alone will turn a conventional fixed wing aircraft, but much more slowly than if ailerons are also used in conjunction. Use of rudder and ailerons together produces co-ordinated turns, in which the longitudinal axis of the aircraft is in line with the arc of the turn, neither slipping (under-ruddered), nor skidding (over-ruddered). Improperly ruddered turns at low speed can precipitate a spin which can be dangerous at low altitudes.
Sometimes pilots may intentionally operate the rudder and ailerons in opposite directions in a maneuver called a forward slip. This may be done to overcome crosswinds and keep the fuselage in line with the runway, or to more rapidly lose altitude by increasing drag, or both.
[edit] Foot notes
[edit] Literature
[edit] See also
[edit] Conventional ship and boat rudders
- Fully balanced rudder
- Semi-balanced rudder
- Spade rudder
[edit] Specialist ship and boat rudders
- Jet flap rudder
- Kitchen rudder
- Pleuger rudder
- Rotating cylinder rudder
- Schilling Rudder
- Voith Schneider Propeller (a combination propulsion and steering unit}
